Tire-to-Wheel Match-Mounting (Vectoring)
Note: After remounting a tire to a wheel or after replacing a tire
and/or a wheel, remeasure the tire and wheel assembly runout in order to verify
that the amount of runout has been reduced and brought to within tolerances.
Ensure that the tire and wheel assembly is properly balanced ...
Body Control Module Programming and Setup
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the control module is not properly configured
with the correct calibration software, the control module will not control
all of the vehicle features properly.
Ensure th ...
Engine Component Description
Cylinder Block
The cylinder hollow frame structured in–line 4 cylinder. The block has 5 crankshaft
bearings with the thrust bearing located on the third bearing from the front
of the engine.
Crankshaft
The crankshaft is a steel crankshaft. It is supported ...