Warning:
When carrying an undeployed inflator module:
When storing an undeployed inflator module:
Failure to observe these guidelines may result in personal injury.
Tire and Wheel Assembly Runout Measurement - On-Vehicle
Raise and support the vehicle.
Closely inspect each tire for proper and even bead seating.
If any of the tire beads were not properly or evenly seated, reseat the
tire bead, then proceed to step 4. Refer to Tire and Wheel Removal and Installation.
Wrap the circumferenc ...
Cylinder Head Removal
Loosen the 12 cylinder head bolts in the sequence as shown. Use the following
procedure:
Loosen the cylinder head bolts 90 degrees.
Loosen the cylinder head bolts 180 degrees.
Note: Do not damage the guide sleeves (4) and (5).
R ...
Engine Front Cover and Oil Pump Assemble
Oil Pump Installation
Note: The oil pump slide spring and pin, as well as the slide
seal and slide seal spring can be ordered as single parts. All other
oil pump components can only be ordered as a replacement kit.
Install the oil pump components in the fo ...