Chevrolet Sonic Owner's Manual: Using the Outside Mirror with the Blind Spot Mirror
1. Set the main mirror so that the side of the vehicle can just be seen and the blind spot mirror has an unobstructed view.
2. When checking for traffic or before changing a lane, look at the main driver/passenger side mirror to observe traffic in the adjacent lane, behind your vehicle. Check the blind spot mirror for a vehicle in the blind zone. Then, glance over your shoulder to double check before moving slowly into the adjacent lane.
Driving with the Blind Spot Mirror
Actual Mirror View
1. When the approaching vehicle is a long distance away, the image in the main
mirror is small and near the inboard edge of the mirror.
2. As the vehicle gets closer, the imag ...
Interior Mirrors
Manual Rearview Mirror
Hold the inside rearview mirror in the center to move it for a clearer view behind
your vehicle. Adjust the mirror to avoid glare from the headlamps behind you. Push
the ta ...
Other materials:
Loss of Control
Skidding
There are three types of skids that correspond to the vehicle's three control
systems:
Braking Skid — wheels are not rolling.
Steering or Cornering Skid — too much speed or steering in a curve causes
tires to slip and lose cornering force.
Acceleration Skid — too muc ...
Immobilizer System Component Programming
This procedure will learn the immobilizer function. If the battery voltage is
low, charge the battery before proceeding with the learn. If the body control module
(BCM) or engine control module (ECM) have been replaced, they must be programmed
before performing this learn procedure.
Dependin ...
Wheel Drive Shafts Description and Operation
Front wheel drive axles are flexible assemblies.
Front wheel drive axles consist of the following components:
A front wheel drive shaft tripot joint (inner joint)
A front wheel drive shaft constant velocity joint (outer joint)
A front wheel drive shaft
The front wheel drive shaft connec ...
0.0053