Chevrolet Sonic Repair Manual: Communication Interface Module Battery Replacement

Chevrolet Sonic Repair Manual / Accessories / Electronics / Communication Interface Module Battery Replacement

Communication Interface Module Battery Replacement
Callout	Component Name
Preliminary Procedure Remove the instrument panel lower compartment. Refer to Instrument Panel Lower Compartment Replacement
1	Communication Interface Module Battery Procedure Disconnect the electrical connector. Reprogramming of the module may be necessary after losing battery power. For programming and set up procedures, refer to Control Module References.

Electronics

...

Communication Interface Module Bracket Replacement

Communication Interface Module Bracket Replacement Callout Component Name Preliminary Procedure Remove the instrument panel low ...

Other materials:

Tire Pressure Light
For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS. When the Light Is On Steady This indicates that one or more of the tires are significantly underinflated. Stop as soo ...

Turn and Lane-Change Signals
Move the lever all the way up or down to signal a turn. An arrow on the instrument cluster will flash in the direction of the turn or lane change. Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is completed. If the lever ...

Brake Pedal Position Sensor Calibration
Calibration Criteria Note: Do not apply the brake pedal during the brake pedal position sensor calibration procedure. Any movement of the brake pedal during this procedure will cause the calibration procedure to fail. If this occurs, the brake pedal position sensor calibrati ...

0.005