Chevrolet Sonic Repair Manual: Fuel Tank Draining
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove the fuel tank filler cap.
- Insert a suitable suction hose into the fuel tank filler pipe.
- Attach a suitable suction hose to the hose used with the hand or air operated pump devise.
- Using a hand or air operated pump drain as much fuel from the tank as possible.
Warning:
Refer to Gasoline/Gasoline Vapors Warning.
Note:
The fuel tank must be drained with a suitable, commercially-available fuel removal unit and suction hose - follow safety regulations and national legislation. The fuel tank is fitted with a refill limit float valve. This is located on the filler neck in the fuel tank. To prevent damaging the refill limit float valve, a suitable suction hose must be used. In the presence of fuel vapors or escaping fuel - observe safety regulations and national legislation. Store drained fuel in a suitable, sealable container.
Fuel Injection Fuel Rail Assembly Replacement
Removal Procedure
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection
and Connection.
Remove engine cover. Refer to Engine Cover Replacement.
Remo ...
Fuel Tank Filler Door Latch Housing Replacement
Fuel Tank Filler Door Latch Housing Replacement
Callout
Component Name
Preliminary Procedures
Remove the rear wheelhouse panel line ...
Other materials:
Steering Wheel Controls
Some audio steering wheel controls could differ depending on the vehicle's options.
Some audio steering wheel controls can be adjusted at the steering wheel.
/
: Press to interact with the available
Bluetooth or OnStar systems.
/
: Press to decline an incoming call,
to end speech ...
Secondary Air Injection System Description
The Secondary Air Injection System aids in the reduction of hydrocarbon exhaust
emissions during a cold start. This occurs when the start-up engine coolant temperature
(ECT) is between −10 to +56°C (14?E33°F), the intake air temperature (IAT) is greater
than −10°C (14°F) and it ...
Fuel Tank Filler Pipe Replacement (Steel Tank)
Removal Procedure
Remove the fuel filler door housing. Refer to
Fuel Tank Filler Door Latch Housing Replacement.
Remove the bracket fastener (1).
Lift and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the fuel tank fille ...
0.0079