Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Fuel Tank Replacement

Chevrolet Sonic Repair Manual / Powertrain / Internal Combustion Powertrain Control / Engine Control / General / Fuel Tank Replacement

Removal Procedure
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Relieve the fuel pressure. Refer to Fuel Pressure Relief.
  3. Drain the fuel Tank. Refer to Fuel Tank Draining.
  4. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle.


  5. Remove the harness cover fastener (1) and harness cover (2).
  6. Disconnect the fuel pump harness electrical connector (3).

  7. Disconnect the vent hose (1)
  8. Loosen the hose clamps (2) and slide the filler hose off the fuel tank.

  9. Disconnect the fuel and evaporative emission connectors (1). Refer to Plastic Collar Quick Connect Fitting Service.


  10. Support the fuel tank with a suitable stand.
  11. Remove the fuel tank strap fasteners (1).
  12. Reposition the fuel tank straps (2) toward the back of the vehicle.

  13. Lower the fuel tank (1).
Installation Procedure

    If replacing the tank, remove the fuel pump module
  1. If replacing the tank, remove the fuel pump module and the evaporative emission canister. Refer to Fuel Tank Fuel Pump Module Replacement  and  Evaporative Emission Canister Replacement.
  2. Transfer parts as necessary.
  3. Raise the fuel tank (1).

    4. Caution:

    Refer to Fastener Caution.

  4. Support the fuel tank with a suitable stand.
  5. Position the fuel tank straps (2) onto the fuel tank.
  6. Install the fuel tank strap fasteners (1) and tighten to 22 Y(16 lb ft)

    .



  7. Connect the fuel and evaporative emission connectors (1). Refer to Plastic Collar Quick Connect Fitting Service.


  8. Connect the vent hose (1) .
  9. Tighten the hose clamps (2) to 4.5 Y(40 lb in).

    and slide the filler hose off the fuel tank.



  10. Connect the fuel pump harness electrical connector (3).
  11. Install the harness cover (2) and tighten the cover fasteners (1).
  12. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
Fuel Tank Fuel Pump Module Replacement (Steel Tank)
Special Tools EN-48279 Fuel Sender Lock Ring Wrench For equivalent regional tools, refer to Special Tools. Removal Procedure Relieve the fuel system pressure. Refer to Fuel Pres ...

Ignition Coil Replacement
Special Tools EN-6009 Remover and Installer Ignition Coil For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the engine wiring harness guide ...

Other materials:

Lane Departure Warning (LDW)
For vehicles with this feature, read the entire section before using it. Warning The LDW system is an aid to help the vehicle stay in the driving lane. It does not steer the vehicle. The LDW system may not: . Provide enough time to avoid a crash. . Detect lane markings under bad weather co ...

Rear Compartment Lid Hinge Torque Rod Replacement
Rear Compartment Lid Hinge Torque Rod Replacement Callout Component Name Warning: Refer to Hood Hold-Open Device Warning. Preliminary Procedure Open and support the rear compartment lid. Special Tools BO-125 ...

Sunroof Actuator Motor Replacement
Sunroof Actuator Motor Replacement Callout Component Name Preliminary Procedure Remove the dome lamp bezel. Refer to Dome Lamp Bezel Replacement. 1 Sunroof Actuator Motor Screw (Qty:?€‰3) ...

© 2014-2025 Copyright www.csmans.com
 
0.0096