Chevrolet Sonic Owner's Manual: Washer Fluid
Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview for reservoir location.
Caution
- . Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
- . Do not mix water with ready-to-use washer fluid. Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
- . When using concentrated washer fluid, follow the manufacturer instructions for adding water.
- . Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full.
What to Use
When the vehicle needs windshield washer fluid, be sure to read the manufacturer's
instructions before use. If operating the vehicle in an area where the temperature
may fall below freezing, u ...
Brakes
If the overheat warning no longer displays, the vehicle can be driven. Continue
to drive the vehicle slowly for about 10 minutes. Keep a safe vehicle distance from
the vehicle in front. If the war ...
Other materials:
Tire Chains
Warning
Do not use tire chains. There is not enough clearance. Tire chains used on
a vehicle without the proper amount of clearance can cause damage to the brakes,
suspension, or other vehicle parts. The area damaged by the tire chains could cause
loss of control and a crash.
Use another typ ...
Front Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools
DT-35910 Drive Axle Boot Clamp Pliers
For equivalent regional tools, refer to Special Tools
Disassemble Procedure
Remove the wheel drive shaft from the vehicle. Refer to Front Wheel
Drive Shaft Replacement.
Install the drive axle shaft (1) i ...
Timing Belt Rear Cover Installation
Re-cut the 4 rear timing belt cover threads.
Install the timing belt rear cover (1).
Caution: Refer to Fastener Caution.
Note: Service may offer bolts that are not microencapsulated.
If this is the case apply thread lock agent to the bolt. If fastener is
...
0.0076