Chevrolet Sonic Owner's Manual: When the System Does Not Seem To Work Properly
If the LDW symbol does not appear:
- The lane markings on the road may not be seen.
- The camera sensor may be blocked by dirt, snow or ice.
- The windshield may be damaged.
- The weather may be limiting visibility.
This is normal operation; the vehicle does not need service. Clean the windshield.
Warning
LDW does not provide a warning to help avoid a crash, unless it detects the lane markings. LDW may not detect the lane markings if the camera sensor is blocked by dirt, snow, or ice, or if the windshield is damaged. It may also not detect a lane on winding or hilly roads, or in conditions that can limit visibility such as fog, rain, or snow, or if the headlamps or windshield are not cleaned or in proper condition. Keep the windshield, headlamps, and camera sensors clean and in good repair.
LDW warnings may occasionally occur due to tar marks, shadows, cracks in the road, or other road imperfections. This is normal system operation, the vehicle does not need service.
How the System Works
The LDW camera sensor is on the windshield ahead of the rearview mirror.
To turn LDW on and off, press the LANE DEPART button on the steering wheel. The
control indicator will light when LDW is o ...
Fuel
...
Other materials:
Vehicle Messages
DIC messages display when the status of the vehicle has changed and action may
be needed to correct the condition. Multiple messages appear one after another.
Press any of the DIC buttons on the turn signal lever to acknowledge and clear
them from the display. More urgent messages cannot be cle ...
Hood Replacement
Hood Replacement
Callout
Component Name
Preliminary Procedure
Disconnect the windshield washer nozzle hose.
1
Hood Hinge Nut (Qty:?€‰4)
Caution: Refer to Fastener Caution.
Procedu ...
Roof Panel Joint Finish Molding Replacement
Roof Panel Joint Finish Molding Replacement
Callout
Component Name
Caution: Refer to Exterior Trim Emblem Removal Caution.
Preliminary Procedures
Begin at the rear edge of the roof panel joint finish molding an ...
0.0057