Transmission Fluid Pump, Front Differential Carrier Baffle, and Front Differential
Ring Gear Removal (6T40/45)
Front Wheel Drive Intermediate Shaft ReplacementFog Lamp Aiming
Preparation Procedure
Note: Horizontal aim is not adjustable on this vehicle. Vertical
aim is done by an adjusting nut located on the rear of the fog lamp. Prior
to aiming the fog lamps, perform the following steps:
Completely assemble all of the components on the vehi ...
Front Wheel Bearing and Hub Replacement
Special Tools
CH-50559 Wheel Hub/Bearing Remover Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the steering knuckle assembly from the vehicle. Refer to Steering
...
Engine Mount Bracket Installation
Install the engine mount bracket (2).
Caution: Refer to Fastener Caution.
Install the 3 engine mount bracket bolts and tighten to 60 Y (45 lb ft) + 45?E0°.
...