Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. |
|
1 |
Front Bumper Fascia Center Support Bolt (Qty:?€‰2) Caution: Refer to Fastener Caution.
9?€‰Y (80?€‰lb?€‰in) |
2 |
Front Bumper Fascia Center Support |
Tire and Wheel Assembly Balancing - Off Vehicle
Warning: Failure to adhere to the following precautions before tire
balancing can result in personal injury or damage to components:
Clean away any dirt or deposits from the inside of the wheels.
Remove any stones from the tread.
Wear eye protection.
Use coated weights on alum ...
Valve Lifter Installation
Special Tool
EN-845 Suction Device
For equivalent regional tools, refer to Special Tools.
Note: Observe the correct locations.
Note: Coat the sliding surfaces with NEW engine oil.
Install the 16 valve lifter (1), using the EN-845 suction device . ...
Crankshaft Balancer Removal
Special Tools
EN-652 Flywheel Holder
For equivalent regional tools, refer to Special Tools.
Install the EN-652 holder (1). Lock the flywheel (2) or the automatic
transmission flex plate via the starter ring gear.
Remove and DISCARD the crankshaft balancer bo ...