Chevrolet Sonic Repair Manual: Front Wheel Drive Shaft Seal Replacement - Left Side

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Front Wheel Drive Shaft Seal Replacement - Left Side

Front Wheel Drive Shaft Seal Replacement - Left Side
Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the left wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement.
1	Left Front Wheel Drive Shaft Oil Seal Procedure For seal removal use GE-6125-1B slide hammer with DT-23129 universal seal remover . For seal installation use GE-8092 driver handle with DT-47790 seal installer . Special Tools DT-23129 Universal Seal Remover DT-47790 Seal Installer GE-6125?B Slide Hammer GE-8092 Driver Handle For equivalent regional tools, refer to Special Tools.

Front Wheel Drive Shaft Seal Replacement - Case Side

Front Wheel Drive Shaft Seal Replacement - Case Side Callout Component Name 1 Front Wheel Drive Shaft Oil Seal Specia ...

Reverse (Gen 1)

When the gear selector lever is moved to the Reverse (R) position (from the Park position) the normally-high 35R pressure control solenoid 2 is commanded ON and the following changes occur in the ...

Other materials:

Tire Inflation Description
When you inflate the tires to the recommended inflation pressures, the factory-installed wheels and tires are designed in order to handle loads to the tire's rated load capacity. Incorrect tire pressures, or under-inflated tires, can cause the following conditions: Vehicle handling co ...

Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted or corroded. If wheel nuts keep coming loose, the wheel, wheel bolts, and wheel nuts should be replaced. If the wheel leaks air, replace it. Some aluminum wheels can be repaired. See your dealer if any of these conditions exist. Your d ...

Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation
Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation Callout Component Name 1 Low and Reverse Clutch Assembly (OWC) Note: The Low and Reverse Clutch Assembly should rotat ...

0.0086