Chevrolet Sonic Repair Manual: General Description
The factory installed tires are designed to operate satisfactorily with loads up to and including the full rated load capacity when these tires are inflated to the recommended pressures.
The following factors have an important influence on tire life:
- Correct tire pressures
- Correct wheel alignment
- Proper driving techniques
- Tire rotation
The following factors increase tire wear:
- Heavy cornering
- Excessively rapid acceleration
- Heavy braking
Aluminum Wheel Refinishing
Finish Damage Evaluation Procedure
Note:
If the wheels are chrome-plated, do not re-plate or refinish
the wheels.
If the wheels are polished aluminum, do not r ...
Metric Wheel Nuts and Bolts Description
Metric wheel/nuts and bolts are identified in the following way:
The wheel/nut has the word Metric stamped on the face.
The letter M is stamped on the end of the wheel bolt.
The thread sizes ...
Other materials:
Hood Ajar Indicator Description and Operation
Hood Ajar Switch
The body control module (BCM) applies B+ to the hood ajar signal circuit
and monitors the voltage to determine the position of the hood. When the hood
is closed, the switch is open and voltage remains high. When the hood is open,
the switch is closed and the voltag ...
Brake Rotor Assembled Lateral Runout Measurement
Special Tools
CH-41013 Rotor Surfacing Kit
CH-42450-A Wheel Hub Resurfacing Kit
CH-45101 Hub and Wheel Runout Gauge
CH-45101-100 Conical Brake Rotor Washers
For equivalent regional tools, refer to Special Tools.
Warning: Refer to Brake Dust Warning.
Note:
B ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
0.009