Manual Rearview Mirror
Hold the inside rearview mirror in the center to move it for a clearer view behind your vehicle. Adjust the mirror to avoid glare from the headlamps behind you. Push the tab forward for daytime use and pull it for nighttime use.
Vehicles with OnStar® have three control buttons at the bottom of the mirror. See your dealer for more information about OnStar and how to subscribe to it. See OnStar Overview.
Using the Outside Mirror with the Blind Spot Mirror
WindowsOverview (Radio with Touchscreen)
1. VOL
(Volume)
Press to decrease or increase the volume.
2. (Power)
Press and hold to turn the power on or off.
3. (Home Page)
Press to go to the Home Page. See Home Page (Radio with Touchscreen).
...
Multi-Axis Acceleration Sensor Module Programming and Setup
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia
Sensor Module (IMU) is not properly configured with the correct calibration
software, the Electronic Brake Control Module will ...
Engine Replacement (Manual Transmission)
Special Tools
J-45859 Wheel Drive Shaft Remover .
CH-807 Closure Plugs .
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the battery and battery tray. Refer to
Battery Tray Replacement.
Relieve the fuel system pressure. Refer to
...