On vehicles with this feature, the sunroof only operates when the ignition is turned to ON/RUN or Retained Accessory Power (RAP) is active.
Open/Close: To open the sunroof, press and hold the rear of the switch. To close the sunroof, press and hold the front of the switch.
Vent: Press and hold the front of the switch to vent the sunroof.
Manually close the sunshade.
The sunroof will not operate if the vehicle has an electrical failure.
See Sunroof.
Roof Panel Joint Finish Molding Replacement
Roof Panel Joint Finish Molding Replacement
Callout
Component Name
Caution: Refer to Exterior Trim Emblem Removal Caution.
Preliminary Procedures
Begin at the rear edge of the roof panel joint finish molding an ...
Instrument Panel Fuse Block Access Hole Cover Replacement (With AAL)
Instrument Panel Fuse Block Access Hole Cover Replacement
Callout
Component Name
1
Instrument Panel Fuse Block Access Hole Cover
Procedure
Grasp the lower edge of the fuse block cover and pull outward disengaging ...
Transmission General Description
The Hydra-matic 6T30/40/45/50 is a fully automatic, 6-speed, front-wheel drive,
electronic-controlled transmission. It consists primarily of a 4-element torque
converter, a compound planetary gear set, friction and mechanical clutch assemblies,
and a hydraulic pressurization and control system ...