Chevrolet Sonic Repair Manual: Transmission Control Replacement
- Removal Procedure
-
- Remove the floor console. Refer to Front Floor Console Replacement.
- Lift both cable adjustment retainers (1), one for each cable, to release the shift lever and selector lever cable.
- Pull the shift lever and selector lever cable retainers (1) from the transmission control assembly (3).
- Remove the shift lever and selector cable from the shift and selector control
- Remove the 4 transmission control bolts (1).
- Remove the transmission control from the vehicle.
.1
- Installation Procedure
-
- Position the transmission control in the vehicle.
- Install the 4 transmission control bolts (1) and tighten
to 9 Y (80 lb in)
.
- Connect the shift lever and selector lever cables to the shift and selector control adjusters (2).
- Install the shift lever and selector lever cable retainers (1) to the transmission control (3)
- Press down and lock both cable adjustment retainers (1), one for each cable, to adjust the shift lever and selector lever cable.
- Adjust the shift lever and selector level cables. Refer to Manual Transmission Shift Lever Cable Adjustment.
- Install the floor console. Refer to Front Floor Console Replacement.
- Verify the correct operation of the transmission control assembly.
Caution:
Refer to Fastener Caution.
.1
Transmission Control Lever Boot Replacement
Transmission Control Lever Boot Replacement
Callout
Component Name
Preliminary Procedure
Remove the front floor console. Refer ...
Automatic Transmission Shift Lock Control Description and Operation
The automatic transmission park lock control system is a safety device that prevents
an inadvertent shift out of PARK. The driver must press the brake pedal before moving
the park lever out of the ...
Other materials:
Front Brake Caliper Overhaul
Disassembly Procedure
Warning: Refer to Brake Dust Warning.
Warning: Refer to Brake Fluid Irritant Warning.
Warning: Do not place fingers in front of the caliper piston(s)
in an attempt to catch or protect it when applying compressed air. The
piston(s) ...
Tire and Wheel Assembly Runout Measurement - Off Vehicle
Raise and support the vehicle.
Mark the location of the wheels to the wheel studs and mark the specific
vehicle position on each tire and wheel – LF, LR, RF, RR.
Remove the tire and wheel assemblies from the vehicle.
Closely inspect each tire for proper and even bead seating.
If an ...
Crankshaft Front Oil Seal Replacement
Special Tools
EN-960 Installer
EN-45000 Remover Oil seal
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement.
Place a drain pan underneath the front crankshaft seal area.
...
0.0063