Rear Disc Brake Pads Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning.
Note: Always replace disc brake pads in axle sets.
Inspect the fluid level in the brake master cylinder reservoir.
If the brake fluid level is midway between the maximum-full point and
the minimum allowab ...
Wheel Drive Shaft Outer Joint Inspection
Disassembly Procedure
Remove the outer constant velocity (CV) joint and boot from the wheel
drive shaft. Refer to Front Wheel Drive Shaft Outer Joint and Boot Replacement.
Remove any lubricant from the CV joint.
Note: Position the cage and the inner race so they a ...
Crankshaft Position System Variation Learn
Note: The crankshaft position sensor system variation learn procedure
is required when the following service procedures have been performed, regardless
of whether DTC P0315 is set:
Engine replacement
Engine control module (ECM) replacement
Crankshaft damper replacement
...