Chevrolet Sonic Repair Manual: Front Wheel Drive Shaft Seal Replacement - Right Side

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Front Wheel Drive Shaft Seal Replacement - Right Side

Front Wheel Drive Shaft Seal Replacement - Right Side
Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the right wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement.
1	Right Front Wheel Drive Shaft Oil Seal Procedure For seal removal use GE-6125-1B slide hammer with DT-23129 universal seal remover . For seal installation use GE-8092 driver handle with DT-47790 seal installer . Special Tools DT-23129 Universal Seal Remover DT-47790 Seal Installer GE-6125-1B Slide Hammer GE-8092 Driver Handle For equivalent regional tools, refer to Special Tools.

Transmission Mount Replacement - Left Side

Removal Procedure Remove the battery tray. Refer to Battery Tray Replacement. Install the engine support fixture. Refer to Engine Support Fixture. Remove and DIS ...

Input Shaft Support Replacement (Gen 1)

Input Shaft Support Replacement Callout Component Name 1 3-5 Reverse and 4-5-6 Clutch Fluid Seals (Qty: 4) ...

Other materials:

Rear Side Door Window Replacement (Sedan)
Rear Side Door Window Replacement Callout Component Name Warning: Refer to Glass and Sheet Metal Handling Warning. Preliminary Procedures Remove the rear side door trim panel. Refer to Rear Side Door Trim ...

SIR Service Precautions
General Service Instructions Warning: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, person ...

Timing Belt Removal
Special Tools EN-6333 Locking Pin EN-6340 Locking Tool For equivalent regional tools, refer to Special Tools. Note: The timing belt drive gear and oil pump housing must align. Turn the crankshaft in the direction of engine rotation, by the crankshaft balancer bolt ...

0.009