Chevrolet Sonic Repair Manual: Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the seat heating control module will not control all of the vehicle features properly.
Ensure that the following conditions exist in order to prepare for seat heating control module programming:
- The battery is fully charged.
- The MDI data link connectors are secure.
- The scan tool is loaded with the most current software version.
- All disconnected modules and devices are reconnected securely.
- This entire procedure has been reviewed before proceeding.
Do not reprogram the seat heating control module unless directed by a service procedure or a service bulletin.
- Seat Heating Control Module Programming
-
To program and setup an existing or new replacement seat heating control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS).
- On the SPS Supported Controllers screen, select HVSMF Front Seat Heating Control Module - Programming and follow the on-screen instructions.
If the HVSMF Front Seat Heating Control Module fails to accept the program, verify all scan tool and seat heating control module connections are secure.
Note:
After programming is completed, perform the following to avoid future misdiagnosis:
- Turn the ignition OFF for 10 seconds.
- Open and close the door.
- Connect the scan tool to the data link connector.
- Ignition ON, engine OFF.
- Clear all DTCs from all modules.
Heated Seats Description and Operation
Heated Seat Components
The driver and passenger heated seats each consist of the following components:
Left heated seat switch
Right heated seat switch
HVAC control module
Seat ...
Other materials:
Instrument Panel Compartment Replacement
Instrument Panel Compartment Replacement
Callout
Component Name
Preliminary Procedure
Remove the right instrument panel upper trim panel. Refer to Instrument
Panel Upper Trim Panel Replacement - Right Side.
...
Engine Replacement (Automatic Transmission)
Special Tools
J-45859 Wheel Drive Shaft Remover
CH-807 Closure Plugs
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the battery and battery tray. Refer to
Battery Tray Replacement.
Relieve the fuel system pressure. Refer to
Fuel Pre ...
Torque Converter Fluid Seal Replacement
Torque Converter Fluid Seal Replacement
Callout
Component Name
1
Torque Converter Fluid Seal Retainer
2
Torque Converter Fluid Seal
Special Tools
DT-47791-A Seal Installer
DT-6125- ...
0.0074