Battery Power Protection
IntroductionBrake Pedal Position Sensor Replacement
Removal Procedure
Remove the instrument panel lower trim pad cover. Refer to Instrument
Panel Lower Trim Pad Cover Replacement.
Disconnect the brake pedal position sensor electrical connector.
Remove the brake pedal position sensor bolt (1).
Remove t ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Valve Lifter Replacement
Special Tools
EN-845 Suction Device
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the camshaft. Refer to Camshaft Replacement.
Note: Mark the assignments.
Remove the valve lifter (1) use the EN-845 suction device ...