Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the rear seat head restraint. Refer to Rear Seat Head Restraint Replacement |
|
1 |
Rear Seat Head Restraint Guide Procedure
Using a suitable flat-bladed tool, slide the tool between the cushion and the guide until you find the slot on the outboard side of the guide. Push inward on the guide slot tab , while pulling upward to remove the guide from the seat back frame. |
Trunk (Sedan)
Warning
Exhaust gases can enter the vehicle if it is driven with the liftgate, hatch/trunk
open, or with any objects that pass through the seal between the body and the hatch/trunk
or liftgate. Engine exhaust contains carbon monoxide (CO) which cannot be seen or
smelled. It can cause unconsci ...
Adhesive Installation of Rear Windows
Warning: Refer to Glass and Sheet Metal Handling Warning.
Use a urethane adhesive systems which meet GM Specification GM?€‰3651G.
Remove all mounds or loose pieces of urethane adhesive from the pinchweld
area.
If the original window is being reused, remove all but approxi ...
Engine Flywheel Removal
Special Tools
EN-652 Flywheel Holder
For equivalent regional tools, refer to Special Tools.
Install EN-652 holder (1) to hold the engine flywheel (2).
Remove and DISCARD the 6 engine flywheel bolts (2).
Remove the engine flywheel (1).
...