Caution:
Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
Parking and Turn Signal Lamp Bulb Replacement
Parking and Turn Signal Lamp Bulb Replacement
Callout
Component Name
Preliminary Procedures
Open and support the hood assembly.
Reposition the air cleaner inlet duct on the passenger side of the
engine compartment.
Re ...
Steering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the
steering angle sensor might be required after certain service procedures are performed.
Some of these procedures are as follows:
Wheel alignment
Steering gear replacement
Steering column replacement
Collision ...
Air Intake System Description
Circuit/System Description
The primary function of the air intake system is to provide filtered air
to the engine. The system uses a filter element mounted in a housing. The filter
housing is remotely mounted and uses intake ducts to route the incoming air
into the throttle body. T ...